Mac Music  |  Pc Music  |  440 Audio Software  |  440Forums  |  440tv  |  Zicos  |  AudioLexic

Bore (wind instruments)

From AudioLexic

Jump to: navigation, search

The bore of a wind instrument is the interior chamber in which air is set into vibration to produce musical sounds. The term is used both for instruments made of wood and instruments made of metal, though of course only in the case of wood instruments is the bore typically produced by boring.

Contents

[edit] Woodwinds

There are two musically useful idealized shapes for the bore of a woodwind instrument, conical and cylindrical. While real world instrument bores intentionally deviate from these shapes, generally they closely approximate one or the other.

[edit] Cylindrical bore

The diameter of a cylindrical bore remains constant with distance from the end of the instrument. The acoustic behavior depends on whether the instrument is stopped (closed at one end and open at the other), or open (at both ends). For an open pipe, the wavelength produced by the first normal mode (the fundamental note) is approximately twice the length of the pipe. The wavelength produced by the second normal mode is half that, that is, the length of the pipe, so its pitch is an octave higher; thus an open cylindrical bore instrument overblows at the octave. This corresponds to the second harmonic, and generally the harmonic spectrum of an open cylindrical bore instrument is strong in both even and odd harmonics. For a stopped pipe, the wavelength produced by the first normal mode is approximately four times the length of the pipe. The wavelength produced by the second normal mode is one third that, i.e. the 4/3 length of the pipe, so its pitch is a twelfth higher; a stopped cylindrical bore instrument overblows at the twelfth. This corresponds to the third harmonic; generally the harmonic spectrum of a stopped cylindrical bore instrument, particularly in its bottom register, is strong in the odd harmonics only.

Instruments having a cylindrical, or mostly cylindrical, bore include:

[edit] Conical bore

The diameter of a conical bore varies linearly with distance from the end of the instrument. A complete conical bore would begin at zero diameter -- the cone's vertex; but most actual instrument bores approximate a frustum of a cone. In either case, the wavelength produced by the first normal mode is approximately twice the length of the cone measured from the vertex. The wavelength produced by the second normal mode is half that, that is, the length of the cone, so its pitch is an octave higher. Therefore, a conical bore instrument, like one with an open cylindrical bore, overblows at the octave and generally has a harmonic spectrum strong in both even and odd harmonics.

Instruments having a conical, or approximately conical, bore include:

[edit] Brasses

Brass instruments also are sometimes categorized as conical or cylindrical, though most in fact have cylindrical sections between a conical section (the mouthpiece taper) and a non-conical, non-cylindrical flaring section (the bell).


To complicate matters these proportions vary as valves or slides are operated; the above numbers are for instruments with the valves open or the slide fully in. Therefore the normal mode frequencies of brass instruments do not correspond to integer multiples of the first mode. However, players of brasses (in contrast to woodwinds) are able to "lip" notes up or down substantially, and to make use of certain privileged frequencies in addition to those of the normal modes, to obtain in-tune notes.


[edit] References

  • Nederveen, Cornelis Johannes, Acoustical aspects of woodwind instruments. Amsterdam, Frits Knuf, 1969.

[edit] See also


This article was started using a Wikipedia (wind instruments) article
Personal tools
In other languages